How to fix windshield glass from a car by yourself

Auto glass cracks can be easily repaired with a composite resin and with a repair kit. To prevent the spread of crack in windshield, repair is important. Consult a specialist car repair if the crack is increased because you may need to be completely replaced auto glass.


1. Clean window residues. Use a moderate amount of glass cleaner. Clean dirt stains on the glass with paper towels or newspapers. Leave the glass to dry thoroughly in the sun before moving to repair the crack.

2. Use a repair kit resin that comes with the syringe. Make sure the disk pedestal is facing up so that the syringe can be inserted.

3. Insert the syringe (supplied with kit) on the pedestal that is connected to the disk. Make sure the suction opening of the syringe plunger down and up on the pedestal. Turn the syringe clockwise until it clicks into place inside the pedestal.

4.Add the plunger until the air bubbles suck and let compound fracture repair in a well ventilated area or in the sun for about 30 minutes. Clean the glass of any excess compound with a wet towel.

How to replace a windshield washer pump Ford Escape

A washer pump work is a must for any car. The option to clean the windshield on the go is something that every driver needs.


  1. Turn the steering wheel all the way to the left, so that the right front wheel is rotated inward.
  2. Remove the dowel pins that hold the inner lining of the right front fender in place, using the pocket screwdriver to lift cores pins. Once the cores are stopped, the pins can pry out by inserting the screwdriver head pocket under the bolt head.
  3. Pull the inner fender liner out of the way.
  4. Use the socket set to remove the fasteners securing the bottle washer in place. Once removed, lower the bottle upside down to get to the pump, located either at the top or side, depending on the year of Escape.
  5. Use the needle nose pliers to disconnect the hose from the washer pump. The hose should be held with small hose clamps that can be released by compressing lashes with tweezers and then pull the hose away.
  6. Turn the washer pump and out of the bottle. Use the pocket screwdriver to disconnect the harness that goes to the pump.
  7. Connect the replacement pump for the harness. Then insert back into the bottle on the reverse of how old was removed.
  8. Reconnect the hose and reinstall the bottle in reverse order. Place the fender liner in place and reinstall the finished pins.

Tips and Warnings

  • Washing nozzle located at the base of the windshield, it can become clogged with hard water deposits if the vehicle has ever used water instead of cleaning fluid. If this happens, take a small piece of wire and clean the nozzle. This uniform spray fluid on the windshield.



How to prevent a windshield cracks extend

How to prevent a windshield cracks from spreading. If you vehicle’s windshield is cracked, you only have two choices. You can pay to change all your windshield or repair cracks. Repair cracks in a windshield can prevent cracks from spreading and reduce the high cost of replacing the entire windshield. Learn how to prevent cracks in a windshield extend these steps.


  1. Examine the crack to determine if it can be repaired or if the entire windshield should be changed. If the cracks are older than 30 days, wider than 1/8 inch (0.31 cm) or longer than 12 inches (30 cm), change the entire windshield.
  2. Take your vehicle to a repair shop windows. A good shop fixing cars with the best glass available and can repair cracked or pitted area. The crack will remain visible but much less noticeable and windshield not split more.
  3. Store Make you a quote. Compare this quote with at least one more glass. Compare the cost of repairs to the cost of replacing the entire windshield. Most windshield repairs cost more but compare that lets you know the difference.
  4. Call your insurance company to see if the repair is covered under your insurance policy. Some insurance policies pay for the repair or replacement of the windshield. Other companies do not cover either, and you must pay the deductible or pay out of pocket for any repair.

How to polish a glass windshield

The common use of things can cause your windshield looks dirtier than you think. Mineral deposits, oil route, pollution and many other agents may leave your windshield with a gritty and rough appearance. In this case, a cleaner common not enough. You need polishing.


  1. Evaluates the natural state of your windshield. If you have a sandy or trademark look, you’ll need a grinder to make it look like new again, but if you are not severely damaged you can polish it with a little physical effort.
  2. Purchase an agent for glass polishing it specifically for windshield. You can get at any auto service or hardware store.
  3. Buy or rent the machine polishing or grinding product, depending on the condition that present your windshield. At last you can get at hardware because the orbital polishers can be used elsewhere. Get at least one disc for polishing for your machine polisher.
  4. Read the manufacturer’s instructions that come with the polishing agent to make sure you apply it properly. Most are placed in circular motions over the entire windshield, allowed to dry and then rinse with water.
  5. Spend a clean microfiber cloth around the windshield to give it a final polish and remove any dirt that is left. When finished, your windshield will shine like new and be totally soft.

How to fix a car window that does not rise?

The car windows are usually a glass sheet within a track with a pulley, which is operated with an automatic or manual crank. When the glass is not lifted or lowered, there are several parts that may be failing and need repair. The average mechanical spend half an hour to remove the door and fix the problem.


  1. Remove the door panel to access the mechanical system of the window. In most vehicles is achieved by removing the screws from behind the inner door handle and pulling the panel to disengage the plastic snap rivets. With manual windows, remove the screw holding the handle to the frame of the window. Once the panel is off, there will be openings in the sheet to access the window pulley and the crank.
  2. Check the position of the window glass inside the track. If the glass has shifted from the track or leaning to one side, you probably will not rise properly. The tracks may have loosened over time and may need to tighten so that the glass fit properly.
  3. In manual windows, check the operation of the crank and connecting mechanism. If turning the crank, not these mechanical arms move, the window will not rise. Normally, the pulley system must be completely replaced when a fail of its mechanical parts.
  4. For electric windows, check the fuse and circuit wiring engine, including the operation switch. Any points in the electrical system can fail and prevent the window from moving. The battery may be dead, or the engine of the car cannot be activated because some vehicles required for the operation of the window. The engine may fail after years of continuous use, and replaced by disconnecting cables to the adapter plug and unbolting it.
  5. Take the glass of the window, if you cannot move. The ice and snow may freeze the glass in place, just as does the vinyl glue and adhesives. Remove or lock unfreeze let’s move the window.

How to clean an automatic windshield

The windshield of your car is in contact with dirt, rain and insects, and this leaves covered with grime, making it difficult to see through them. A dirty windshield can be dangerous in many ways. A windshield covered with insects or mud impairs vision during daytime driving. It is especially dangerous at night, when the other lights shine in your windshield, sometimes causing the light reflects in your eyes. Learn to clean the windshield so you do not endanger yourself or your passengers.


  1. Lava car windshield with soap and water. Rub the windshield with a sponge to remove stuck insects and heavy dirt. If washing the whole car, wash the windshield at the end. Park the car in the shade and let the glass dry completely.
  2. Microfiber towel moistened with cleaning automotive glass. Clean the windshield, using small circular motions. Spray the cleaner directly onto the windshield for stubborn stains.
  3. Use a clean part of the towel to apply the cleaning of glasses for the second time. Clean the windshield from top to bottom, then from side to side, with long strokes.
  4. Turn the microfiber towel to expose a clean and dry part, to polish the windshield and remove any remaining cleanser crystal and stripes.
  5. Pour some polish glasses on a foam pad. Pull the outside of the windshield with small circular movements. Once the product starts to dry, I remove it with a clean, dry microfiber towel.
  6. Clean the inside of the windshield with a microfiber towel and cleaning of automotive glass. Dampen a towel to clean microfiber cleaning glass and clean the glass up and down, and then side to side. Buff with a clean cloth to remove any stripe.

How to clean a fuzzy windscreen

Blurred glass windshield can make you feel like you are driving through fog, even under clear management. The dirt road or other vehicles deposits accumulate on the windshield and cause problems if not clean. The dirt on your windshield is not just dirt; may contain salt, tar, tree sap, oil and other liquids self. This film layer is a security risk during inclement weather when raindrops few transform the toxic sludge mixture. Make an effort to keep you safe cleaning your windshield and other auto glass at least once a month.


  1. Sprinkle the outside of the windshield and windows with a degreasing detergent and water. Auto glass is exposed to contaminants oily and sticky that glass cleaners can cost them penetrate. Rub the glass with a soft cloth. Wash your car and rinse with clean water.
  2. Fill a spray bottle with white vinegar 1/3. Fill the remaining 2/3 with distilled water. Tap water can contain chemicals that cause the glass is scratched. Make a lid of detergent or cleaner neutral ph. Shake the bottle of cleaner household glass to mix the ingredients.
  3. Spray the cleaner on the windshield glass and clean it periodically. Clean from the top to the base of the windshield with broad strokes. Work on the outside of the glass and go inward, working in a window at a time. The newspaper has an effect of polished glass and mirrored surfaces.
  4. Spray wax auto glass, such as those made ​​by RainX, Aquapel or Glass Science, outside your windows. Pule wax through the windshield with a movement circulate. The wax glass allows rain flowing streams windshield. Apply this product to lights and exterior mirrors for improved visibility during storms.
  5. Pule and dry the glass with a microfiber towel. These towels are lint-free and will not scratch the glass surface of the car.